DogWatch R8 Spécifications télécharger pdf (Page 6)

Handy Programming Tips

Recommended Settings: The majority of dogs respond well to transmitter Rate

Setting 2 or 3 and a receiver Training Level 3, 4 or 5. Sensitive or small dogs that train

easily respond best to lower rate settings and lower training levels. If your dog is not

responding to training, your DogWatch Dealer will adjust your system to a higher

training level.

If Your Dog Is Hard To Train: Training Levels 5, 6 and 7 of your receivers are

specifically designed to meet the needs of hard to train or stubborn dogs. These

setting will provide the extra correction that some dogs need as part of their training.

Multiple Dogs: Our receivers allow you to select Audible Only as your Training Level

setting on each individual receiver — allowing you to conduct training with one dog

while the other is still protected with the correction feature enabled. It is recommended

that the Audible Only setting be used only during supervised training sessions.

8 9

SETTING THE TRANSMITTER

Rates The Transmitter Rate switch adjusts to three settings: (1 = slow, 2 = medium,

3 = fast). When your dog gets a correction, he receives it in a series of pulses per

second. Increasing the rate means that he will receive a greater number of pulses per

second. Rate 1 is the slowest pulse rate per second; 3 is the fastest.

Training Modes The Training Mode switch allows you to choose between two

training options: Basic (Mode A) and QuickAlert

(Mode B). When in the Basic setting

your pet will receive an audible warning followed by a correction. For harder to train

dogs, when set to the QuickAlert mode, your pet will receive a very quick “alert”

correction followed by the normal audible warning and correction.

SETTING THE RECEIVER

Receiver Training Levels Your receiver provides eight training levels that allow you

to customize the training setting to your dog’s individual needs: Audible Only, Level 1

(extra low), Level 2 (low), Level 3 (low medium), Level 4 (medium), Level 5 (medium

high), Level 6 (high), and Level 7 (extra high). When the receiver is first shipped from

the manufacturer, it will automatically be set to Training Level 2 (low).

Changing the Receiver Settings Your Dogwatch Dealer will start the training on

the appropriate level according to your dog’s personality and traits. If you need to

change the Training Level on the receiver, hold your test light magnet to the two

raised lines on the side of the receiver (see Figures 1 and 2). Hold the magnet steady

and you will hear a series of beeps that indicate the current training level. The

“Audible Only” level is one long beep, Level 1 is one short beep, Level 2 is two short

beeps, Level 3 is three short beeps, etc. The Training Level will continue to advance

while the magnet is held in position. When you reach the desired setting, pull the

magnet away from the receiver. The receiver is now set.

Note: Any time the magnet activates the receiver, the number of beeps will indicate

the current receiver level. As long as the magnet is held in place, it will advance the

receiver to the next training level and continue to cycle through the settings in the

order shown in the chart on Page 9.

Figure 6: Using the test light magnet to

reset the R7 Receiver

Figure 7: Using the test light magnet to

reset the R8 Receiver

Programmable Features

You can customize the receiver to one of 20 training settings, as outlined in the chart on

the right.

Receiver Levels and Transmitter Settings

*** IMPORTANT ***

Never change the Receiver Training Levels when your dog is wearing the collar.

R A N S M I T T E R M O D E A N D R A T E S E T T I N G S

ode A Mode A Mode A Mode B

Rate 1 Rate 2 Rate 3 QuickAlert

ransmitter Rate Fixed at Medium

Slow Medium Fast Slow

Slow Medium Fast Medium

Slow Medium Fast Fast

Fast Fast

X-Fast X-Fast

XX-Fast XX-Fast

Audible and XXX Fast Correction are Simultaneous

AutoMemory

self activates

and advances

to the next level.

RECEIVER

TRAINING

EVELS

Audible Only

(extra low) 1

(low) 2

(low medium) 3

(medium) 4

(medium high) 5

(high) 6

(extra high) 7

}

For example: If the receiver is on Level 1 and the transmitter is on Rate 1, your dog will receive the

lowest level of correction and the least number of pulses per second.

Please remember that if your Receiver Level is set to 1, 2, or 3 and you switch the Training Mode to

QuickAlert (Mode B), your training setting may change. For example, if the receiver is set to Level 3 and

the transmitter is set to Rate 1, your dog will receive a slow correction. If you switch your Training Mode

to QuickAlert, your dog will now receive a fast correction.

1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire

DogWatch R8 Spécifications Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Soins des animaux DogWatch R8