DogWatch R8 Guide d'installation Page 1

DogWatch Hidden Fence Systems System 1200 & Performance Series Installation Guide

Below are the instructions for installing your DogWatch System. The battery life on the RG1200 & R7 receiver collars = 6 months and on the R

Diagram to illustrate various installation layouts:- Attaching to fencing. If attaching to a fence use a cable clip or staples

Use an angle grinder or disc cutter to cut a slot approx ½” deep and insert the cable into the slot. Make sure the cut is wide enough to comfortably

SURGE PROTECTOR – Protects the system from lightening strikes. 1. Locate the surge protector outside where the zip wire and green ground wire exit

INSTALLING 1. Determine where you want the inside edge of the signal field to be and mark it with your training flags. Flags should be 10ft apart.

!!YOU MUST COMPLETE THIS SECTION OTHERWISE YOUR UNIT WILL NOT WORK!! SETTING THE RANGE – VIP All units are sent out with the range on zero – if you

2. If your dog has been on a hidden fence system before then you do not have to follow the beep training phase. For all other dogs you should follow

How to Use the Yellow Connectors. Step 1: To join the 2 ends of the cable…… Step 2: Strip back approx ½” of the plastic jacket to expose the